Tian Fang, Gong Zhong-lin. The Electromagnetic Leakage of Shielded-Twist-pair with a Transverse Slot[J]. Journal of Electronics & Information Technology, 2007, 29(5): 1243-1246. doi: 10.3724/SP.J.1146.2006.00227
Citation:
Tian Fang, Gong Zhong-lin. The Electromagnetic Leakage of Shielded-Twist-pair with a Transverse Slot[J]. Journal of Electronics & Information Technology, 2007, 29(5): 1243-1246. doi: 10.3724/SP.J.1146.2006.00227
Tian Fang, Gong Zhong-lin. The Electromagnetic Leakage of Shielded-Twist-pair with a Transverse Slot[J]. Journal of Electronics & Information Technology, 2007, 29(5): 1243-1246. doi: 10.3724/SP.J.1146.2006.00227
Citation:
Tian Fang, Gong Zhong-lin. The Electromagnetic Leakage of Shielded-Twist-pair with a Transverse Slot[J]. Journal of Electronics & Information Technology, 2007, 29(5): 1243-1246. doi: 10.3724/SP.J.1146.2006.00227
This paper propose a quantitative analysis on the electromagnetic leakage from a shielded-twist-pair with a transverse slot. The mechanism of electromagnetic leakage is analyzed, and then the slotted shielded-twist-pair is regarded as a cascaded network. By applying the hybrid-method, which is the combination of the chain-parameter-equation, the finite-element-method and the subcell-FDTD-method, the electromagnetic leakage from the transverse slot on the shield of the twist-pair are simulated. The results show that, below the frequency of 500MHz, the leaked energy from the slotted shielded-twist-pair is no more than 1% even if the shield layer is cut off.
Hamada S, Kawashima T, and Ochura J. Influence of balance-unbalance conversion factor on radiated emission characteristics of balanced cables. IEEE International Symp. on Electromagnetic Compat., 2001: 31-36.[2]Taflove A, Umashankar K R, and Beker B, et al.. Detailed FD-TD analysis of electromagnetic fields penetrating narrow slots and lapped joints in thick conducting screens[J].IEEE Trans. on Antennas Propagat.1988, 36(2):247-257[3]田方,龚中麟.混合方法模拟差模传输线的共模电磁泄漏[J].电子与信息学报.2005, 27(12):2000-2004浏览[4]田方,龚中麟.基于混合方法模拟纵向长切缝同轴线的电磁泄漏.高技术通讯(增刊), 2004: 204-208.[5]Watanabe T, Wada O, and Toyota Y. Estimation of common- mode EMI caused by a signal line in the vicinity of ground edge on a PCB. IEEE International Symp. on Electromagnetic Compat., Minneapolis, Minnesota, USA, 2002: 113-118.[6]Paul C R. Useful matrix chain parameter identities for the analysis of multiconductor transmission lines[J].IEEE Trans. on MTT.1975, 23(9):756-760